Managed Switch Led Indicators; Initial Setup Of The Ethernet Switch Module - GE D30 Instruction Manual

3.4 MANAGED ETHERNET SWITCH MODULES
The wiring for the managed Ethernet switch module is shown below.
3
The 10/100Base-T and 100Base-FX ports have LED indicators to indicate the port status.
The 10/100Base-T ports have three LEDs to indicate connection speed, duplex mode, and link activity. The 100Base-FX
ports have one LED to indicate linkup and activity.
a) DESCRIPTION
Upon initial power up of a D30 device with an installed Ethernet switch, the front panel trouble LED will be illuminated and
the
ENET MODULE OFFLINE
place it online. This involves two steps:
1. Configuring the network settings on the local PC.
2. Configuring the D30 switch module through EnerVista UR Setup.
These procedures are described in the following sections. When the D30 is properly configured, the LED will be off and the
error message will be cleared.
3-40
Figure 3–47: MANAGED ETHERNET SWITCH MODULE WIRING
Connection speed indicator (OFF = 10 Mbps; ON = 100 Mbps)
Link indicator (ON = link active; FLASHING = activity)
Duplex mode indicator (OFF = half-duplex; ON = full-duplex)
Link indicator (ON = link active; FLASHING = activity)
Figure 3–48: ETHERNET SWITCH LED INDICATORS
error message will be displayed. It will be necessary to configure the Ethernet switch and then
D30 Line Distance Protection System

3.4.3 MANAGED SWITCH LED INDICATORS

3.4.4 INITIAL SETUP OF THE ETHERNET SWITCH MODULE

3 HARDWARE
842868A2.CDR
GE Multilin