Managed Switch Led Indicators; Configuring The Managed Ethernet Switch Module - GE t60 Instruction Manual

3.4 MANAGED ETHERNET SWITCH MODULES
The wiring for the managed Ethernet switch module is shown below.
3
The 10/100Base-T and 100Base-FX ports have LED indicators to indicate the port status.
The 10/100Base-T ports have three LEDs to indicate connection speed, duplex mode, and link activity. The 100Base-FX
ports have one LED to indicate linkup and activity.
A suitable IP/gateway and subnet mask must be assigned to both the switch and the UR relay for correct operation. The
Switch has been shipped with a default IP address of 192.168.1.2 and a subnet mask of 255.255.255.0. Consult your net-
work administrator to determine if the default IP address, subnet mask or default gateway needs to be modified.
Do not connect to network while configuring the switch module.
CAUTION
3-42
MM fiber optic cable
MM fiber optic cable
MM fiber optic cable
MM fiber optic cable
100Base-T cable
100Base-T cable
+
110 to 250 V DC
100 to 240 V AC –
Figure 3–47: MANAGED ETHERNET SWITCH MODULE WIRING
Connection speed indicator (OFF = 10 Mbps; ON = 100 Mbps)
Link indicator (ON = link active; FLASHING = activity)
Duplex mode indicator (OFF = half-duplex; ON = full-duplex)
Link indicator (ON = link active; FLASHING = activity)
Figure 3–48: ETHERNET SWITCH LED INDICATORS

3.4.4 CONFIGURING THE MANAGED ETHERNET SWITCH MODULE

T60 Transformer Protection System
Tx1
100Base-FX
Rx1
Tx2
100Base-FX
Fiber
Rx2
ports
Tx1
100Base-FX
Rx1
Tx1
100Base-FX
Rx1
10/100Base-T
Copper
ports
10/100Base-T
+
W1a
W2b ― Power supply
W1a
GROUND
842835A1.CDR

3.4.3 MANAGED SWITCH LED INDICATORS

842868A2.CDR
3 HARDWARE
GE Multilin