Sspb Specifications; Table 1: Electrical Specifications - Advantech SSPBMg–C200–BRE Installation And Operating Manual

2.3 SSPB SPECIFICATIONS

TABLE 1: ELECTRICAL SPECIFICATIONS

L-Band Input Frequency
RF Output Frequency Range
Frequency Stability
RF Saturated Output Power (P
Linear Output Power (P
Linear Gain
Gain Flatness:
Gain Variation Over Temperature
L-Band Input Impedance
L-Band Input VSWR
C-Band Output VSWR
Noise Power Density
Spurious at rated P1dB
(in-band and out of band)
Third Order Intermodulation
(two equal tones 5 MHz apart)
Local Oscillator Frequency
Local Oscillator Leakage
Integrated Phase Noise @ P
Output Phase Noise
@ Offset
.
*NOTE: To establish P
apart to be – 25 dBc, related to total output power and record the total output power for this value
of IMD3.
950 – 1525 MHz
5.850 – 6.425 GHz
Based upon 10 MHz Internal Reference
) + 53 dBm, typical (200 W)
SAT
)* + 50.0 dBm, min
LIN
75 dB, typical
over 575 MHz 3.0 dB, p-p, max
over 40 MHz 1.0 dB, max
3 dB, p-p, over the entire bandwidth
50 Ω
1.29:1, max
1.3:1, max
- 75 dBm/Hz, max (in transmit band)
- 155 dBm/Hz, max (in receive band)
- 55 dBc, max
- 25 dBc, max @ 50.0 dBm total output power,
referenced to total output power
4.900 GHz
- 20 dBm, max
2 °/RMS
LIN
C-Band Single Side Band Phase Noise (max)
100 Hz - 63 dBc/Hz
1 kHz - 73 dBc/Hz
10 kHz - 83 dBc/Hz
≥100 kHz
- 93 dBc/Hz
measure third order intermodulation with two equal tones 5 MHz
LIN
SSPBMg-C200-BRE
Page 13