Selecting The Monitor (Designation Of The Monitor Or Group Id Number) - Sony BVM-E251 Operating Instructions Manual

Selecting the Monitor
(Designation of the
Monitor or Group ID
Number)
When the multiple monitors are connected by network
connections, you can remotely connect the monitors
from the controller by designating the set monitor ID
number or group ID number.
Display window
Indicator
1
Press the corresponding button to select the
connection mode.
SINGLE button: Selects single connection mode.
The designated monitor is connected remotely.
The monitor ID number is displayed on all
connected monitors when the button is held down.
GROUP button: Selects group connection mode.
The monitor of the designated group is connected
remotely.
The group ID number is displayed on all connected
monitors when the button is held down.
ALL button: Selects all connection modes.
All monitors are connected remotely.
The indicator corresponding to the pressed button
flashes and lights after recognizing the monitor.
2
Select the monitor ID number for the single
connection mode or group ID number for the
group connection mode by pressing the UP/
DOWN or numeric button.
Up to 99 is entered as the monitor ID or group ID
number.
3
Press the ENTER (Ent) button to confirm the
setting.
The monitor ID number, group ID number, or ALL
is displayed in the display window.
Notes
 When the monitor with no assigned monitor ID
number or group ID number is selected, the setting is
not changed and the previous connection status is
maintained
When there are monitors with the same ID number,

the monitor with the lower IP address is selected.
 Even if a different monitor ID number is set to the
monitors, when the same IP address is set to another
monitor, the monitor cannot be connected to the
network.

Selecting the Monitor (Designation of the Monitor or Group ID Number)

23