Sony BVM-E251 Operating Instructions Manual page 36

The current channel is displayed.
Perform the input setting for the selected channel.
Before setting
Set the input signal for each channel. A channel number
(1 to 30) is entered with the numeric buttons (page 27).
Note
This menu is not selectable in the following cases:
When [Side by Side] is set to [On]

When [Wipe] is set to [On]

When [Butterfly] is set to [On]

 When [Blending] is set to [On]
Submenu Setting
[Format] Sets the input signal type.
For details of the setting, see [Format]
(page 38).
Note
The default setting is [3G/HD/SD-SDI
Auto].
36
Adjustment Using the Menus
Submenu Setting
[Input No] Enters the input connector number if
there are two inputs with the same type
of input connectors.
When [Format] is set to [3G/HD/SD-
SDI Auto] or [4:2:2 YCbCr 10bit] or
[4:4:4 YCbCr 10bit], [4:4:4 RGB 10bit],
[4:4:4 YCbCr 12bit], [4:4:4 RGB 12bit],
[4:4:4 XYZ 12bit] of [3G-SDI], [HD/
SD-SDI Auto], [SD-SDI], select from
the following:
[Input1]

[Input2]

When [Format] is set to [4:2:2 YCbCr
10bit] or [4:4:4 YCbCr 10bit], [4:4:4
RGB 10bit], [4:4:4 YCbCr 12bit], [4:4:4
RGB 12bit], [4:4:4 XYZ 12bit] of [Dual
Link HD-SDI], [Input1&2] is selected.
[Screen Aspect] Selects the aspect ratio.
For details of the setting, see [Screen
Aspect] (page 38).
[Color Temp] Sets the color temperature.
Except for the XYZ format signal
Select from the following:
[D93]

[D65]

[D61]

[D55]

[DCI]

[User1] to [User5]

When [DCI] is selected, the color
temperature is set to x=0.314 and
y=0.351 in the CIE chromaticity
coordinate.
When [D93], [D65], [D61], [D55], or
[DCI] data is changed, they are
displayed as [D93*], [D65*], [D61*],
[D55*], or [DCI*].
For the XYZ format signal
Select from the following:
[DCI XYZ]

[User XYZ1] to [User XYZ5]

When [DCI XYZ] data is changed, it is
displayed as [DCI XYZ*].
Note
If you measure the color temperatures
of different display types, such as CRT,
LCD, or OLED, by using a common (or
general) color analyzer that is based on
CIE 1931, and adjust the xy
chromaticity to the same value, the
appearance may be different because of
optical spectrum differences.
To compensate for this difference, the
[D93], [D65], [D61], [D55], and
[User1] to [User5] settings (except
[DCI]) of the monitor are adjusted by
an offset
1) The offset value applied (x-0.006, y-
0.011) is based on the Judd's function
to the CIE 1931 (x, y) value.
1)
.