Specifications; Bvm-E251 - Sony BVM-E251 Operating Instructions Manual

Specifications

BVM-E251

Picture performance
Panel OLED panel
Picture size (diagonal)
623.4 mm (24
Effective picture size (H × V)
543.4 × 305.6 mm
1
(21 /
2
Resolution (H × V)
1920 × 1080 pixels (Full HD)
Aspect 16:9
Pixel efficiency 99.99%
Panel drive RGB 10-bit
Panel display frame rate
48 Hz, 50 Hz, 60 Hz
See "Picture Frame Display" (page 97).
Viewing angle (Panel specification)
89°/89°/89°/89° (typical)
(up/down/left/right, contrast > 10:1)
Normal scan 0% scan
Native scan Mapping the pixels of the signal to the
panel to one-to-one mode, or
displaying an SD signal of non-
square pixels (the number of H
pixels of the signal system is 720 or
1440) or a 640 × 480 SD signal of
HDMI video by scaling processing
of doubling for the V direction and
correct aspect ratio for the H
direction and also optimizing and
displaying a picture by modifying
the aperture coefficient value, filter
coefficient value, etc.
Under scan 3% under scan
Over scan Mask of 5% over scan portion in the
normal scan
Color temperature
D55, D61, D65, D93, DCI
possible in other color temperature)
Standard luminance (100% white signal input)
2
100 cd/m
2
48 cd/m (Preset(DCI))
Color space (color gamut)
ITU-R BT.709, EBU, SMPTE-C, DCI-
3)
P3 , E251 Native
GAMUT3
ITU-R BT.2020
Warm-up time Approx. 30 minutes
To provide stable picture quality, turn
on the power of the monitor and
5
/ inches)
8
1
× 12 / inches)
8
1)
2)
(Setting
(Preset1-Preset5)
4)
, S-GAMUT/S-
5)
, S-GAMUT3.Cine,
leave it in this state for more than 30
minutes.
1) 48 Hz and 60 Hz are compatible with a frame rate of 1/
1.001.
2) DCI: x=0.314 y=0.351
3) Chromaticity points of SMPTE RP 431-2, ITU-R BT.2020,
S-Gamut/S-Gamut3, and S-Gamut3.Cine are not covered
in full.
4) The BVM-E251 individual chromaticity points. The widest
color space setting of the signal reproduced by the BVM-
E251
x
R 0.681
G 0.189
B 0.141
5) For displaying the color space of the wide color space mode
which is available for the F65 or PMW-F55/F5 CineAlta 4K
Camera, etc.
Input
SDI BNC (×2)
Input impedance: 75 ohms unbalanced
Signal format: See "Available Signal
Formats" (page 88).
Sampling frequency
3G-SDI:
Y/Cb/Cr (4:2:2): 148.5 MHz/74.25
MHz/74.25 MHz
Y/Cb/Cr (4:4:4): 74.25 MHz/74.25
MHz/74.25 MHz
G/B/R (4:4:4): 74.25 MHz/74.25
MHz/74.25 MHz
HD-SDI:
Y/Cb/Cr (4:2:2): 74.25 MHz/37.125
MHz/37.125 MHz
SD-SDI:
Y/Cb/Cr (4:2:2): 13.5 MHz/6.75
MHz/6.75 MHz
Quantization
3G-SDI: 10bit/sample, 12bit/sample
HD-SDI: 10bit/sample
SD-SDI: 10bit/sample
Composite input (NTSC/PAL/PAL-M)
BNC type (×1)
1 Vp-p ±3 dB sync negative
HDMI HDMI (×1)
HDCP1.4 correspondence, Deep Color
correspondence
Signal format: See "HDMI" (page 92)
of "Available Signal Formats".
Parallel remote RJ-45 (×1)
Serial remote (LAN)
Ethernet (10BASE-T/100BASE-TX)
RJ-45 (×1)
y
0.319
0.724
0.051
(Typical)
Specifications
85