Sony BVM-E251 Operating Instructions Manual page 61

Submenu Setting
[IP Address] Sets the IP address. (Default value:
[192.168.000.001])
Note
When the NETWORK switch is set to
PEER TO PEER, the IP address is set to
"192.168.0.1" regardless of the display.
When the NETWORK switch is set to
LAN, the IP address is set to the
displayed one.
[Subnet Mask] Sets the subnet mask. (Default value:
[255.255.255.000])
Note
When the NETWORK switch is set to
PEER TO PEER, the subnet mask is set
to "255.255.255.000" regardless of the
display.
When the NETWORK switch is set to
LAN, the subnet mask is set to the
displayed one.
[Default Gateway] Sets whether or not to set the default
gateway ([Off] or [On]).
[Address] Sets the address of the default gateway.
(Default value: [---.---.---.---] (no
setting))
[Cancel] Cancels the changed or confirmed
setting.
[Confirm] Saves the changed or confirmed setting.
[Protocol Setting]
Sets the required items for communications such as the
port number.
For the setting value, consult the network administrator.
Submenu Setting
[SDCP/SDAP Sets the SDCP/SDAP community
Community] name.
When the item is selected, you can enter
the community name (four characters).
[SONY]: SONY is entered as a

community name.
[New Name]: Enter a new name.

[SDCP Port No] Sets the SDCP port number.
Set from 53434 to 53534. (Default value:
[53484])
[SDAP Port No] Sets the SDAP port number.
Set from 53812 to 53912. (Default value:
[53862])
[SDAP Broadcast] Sets whether or not to issue the SDAP
([Disable] or [Enable]).
[SDAP Broadcast Sets the period (seconds) to issue the
Period] SDAP.
Set from 05 to 30. (Default value: [15])
Submenu Setting
[Acceptable IP Sets the IP address to connect.
Address] When the item is selected, you can set
[IP1] to [IP4].
[Cancel]: Cancels the changed or

confirmed setting.
[Confirm]: Saves the changed or

confirmed setting.
[Reset Protocol Resets the protocol setting.
Setting] When the item is selected, the following
message appears.
[Are you sure ?]
[OK]: To reset data, press the

ENTER (Ent) button.
[Cancel]: To cancel, press the

MENU button.
[Parallel Remote]
Sets the parallel remote function.
Submenu Setting
[Parallel Remote] Selects whether or not to use the
parallel remote functions ([Off] or
[On]).
61
Adjustment Using the Menus