WARNING
Using this unit for medical purposes
The connectors on this unit are not isolated.
Do not connect any device other than one which
conforms to IEC 60601-1 standards.
When an information technology device or AV device
that uses an alternating current is connected, current
leakage may result in an electric shock to the patient or
operator.
If use of such a device is unavoidable, isolate its power
supply by connecting an isolation transformer, or by
connecting an isolator between the connecting cables.
After implementing these measures, confirm that the
reduced risk now conforms to IEC 60601-1 standards.
20
Connecting the AC Power Cord
Connecting the AC Power
Cord
LMD-X310MT
1
Make sure that the (On)/
to
(in a standby state).
2
Insert the DC connector to the DC 26 V input
connector of the rear panel until it locks.
3
Plug the AC power cord into the AC IN connector
of the AC adaptor and attach the AC power plug
holder to the AC power cord.
AC IN connector
4
Insert the AC power plug holder until the fixing
lever locks.
(Standby) switch is set
AC power cord
AC power plug holder