Table of Contents
Advertisement
2) Transmission distance
HD-SDI: 100 m (approx. 328 ft) max. (When using SC-FB
coaxial cables (Fujikura. Inc.) or equivalent.)
SD-SDI: 200 m (approx. 656 ft) max. (When using SC-2V
coaxial cables (Fujikura. Inc.) or equivalent.)
Q -8 HDIS input connector (D-sub 15-pin, female)
The Plug & Play function corresponds to DDC2B.
0 DVI-D input/output connector (DVI-D)
-8 connector
Input DVI Rev.1.0 applicable digital signal.
ß. connector
Active through output connector of the DVI digital
signal.
Outputs the signal which inputs to the -EJ connector.
The signal protected by HDCP I) is not ou
1) HDCP (High-bandwidth Digital Content Protection) is a
copyright protection technology using encryption
technology of digital video signals.
A signal is output from the connector only when the
monitor is turned on. When the monitor is tumed off,
the signal is not output from the connector.
� -8 VIDEOinput connector (BNC type)
The input connector for composite signals.
-8 S-VIDEO input connector (4-pin mini-DIN)
The input connector for Y /C signals.
Do not come into contact with the terminals of the rear
panel connectors and patients at the sarne time.
Doing so may result in a generation of voltage that can be
harmful to patients if the unit is malfunctioning.
Always disconnect the power cord before connecting
and disconnecting connectors.
Using this unit for medical purposes
The connectors on this unit are not isolated.
Do not connect any device other than one which
conforms to IEC 60601-1 standards.
When an informa
ion technology device or AV device
that uses an altemating current is connected, current
leakage may result in an electric shock to the patient or
operator.
If use of such a device is unavoidable, isolate its power
supply by connecting an isolation transformer, or by
connecting an isolator between the connecting cables.
After implementing these measures, confirm that the
reduced risk now conforms to IEC 60601-1 standards.
t
l@ti
&
[I!]
Caution
[I!]
Warning
Press the C) side ofthe 1 (On)/ 0 (Standby) switch
and switch the unit to the standby state.
Slide the shutter of the AC connector of the unit to
the right, then insert the AC power cord into the AC
input connector as illustrated.
put.
To use the AC adaptor (sold separately)
Switch the unit to the standby state by pressing the C)
side ofthe 1 (On)/ C) (Standby) switch, slide the shutter
of the power connector on the unit to the left, then insert
the DC connector into the DC input connector until it
locks. Next, insert the AC power cord into the separately
sold AC adaptor.
�coooecto,
t
Connecting the Power
Cord
To connect the power cord
1
2
0
Shutter
��
--""TT"-.....
III·
AC input conn
� j �
� t� ::
0
��
0
A�
0
DC connector
T
r
O
Connecting the Power Cord
0
ctor
r
e
tte
0
119
Advertisement
Table of Contents
