Lines / Dial Plan; Lines / Basic Settings; Figure 69 - Dial Plan Configuration; Table 4 - Basic Settings For Lines On Web - New Rock Technologies NRP1002/P User Manual

NRP1002/P IP Phone User Manual

8.14 LINES / Dial Plan

The device supports 8 dialing modes:

Press # to Send - Dial the desired number, and press # to send it to the server.
 Dial Fixed Length – Configure the fixed length to dial out
 Send after seconds – Number will be sent to the server after the specified time.

Press # to Do Blind Transfer - Press # after entering the target number for the transfer. The phone will
transfer the current call to the third party.

Blind Transfer on Onhook - Hang up after entering the target number for the transfer. The phone will
transfer the current call to the third party.

Attended Transfer on Onhook - Hang up after the third party answers. The phone will transfer the current
call to the third party.

Attended Transfer on Conference Onhook - Hang up during a 3-way conference call, the other two ways
will make a call.
 Press DSS Key to Do Blind Transfer – When user is in the 'XFER' screen, user can fulfill Blind Transfer
by pressing DSS Key.

8.15 LINES / Basic Settings

Configure basic settings for lines.
Parameters
SIP Settings
Local SIP Port
Registration Failure Retry Interval
STUN Settings
Server Address
www.newrocktech.com

Figure 69 - Dial Plan Configuration

Table 4 - Basic Settings for Lines on Web

Description
Set the local SIP port used to send/receive SIP messages.
Set the retry interval of SIP REGISTRATION when registration
failed.
Set the STUN server address
48/68