New Rock Technologies NRP1002/P User Manual page 51

NRP1002/P IP Phone User Manual
Enable Intercom Mute
Enable Intercom Tone
Enable Intercom Barge
Auto Answer By Headset
Ring From Headset
Emergency Call Number
Enable Password Dial
Password Dial Prefix
Enable Phone DND
DND Response Code
Busy Response Code
Reject Response Code
Encryption Number Length
Restrict Active URI Source
IP
Push XML Server
Allow IP Call
Enable Multi Line
Enable Default Line
Enable Auto Switch Line
Play Talking DTMF Tone
Play Dialing DTMF Tone
Caller ID Display Priority
www.newrocktech.com
answer the call after specific delay.
Enable mute mode during the intercom call
If the incoming call is intercom call, the phone plays the intercom tone
Enable Intercom Barge by selecting it, the phone auto answers the
intercom call during a call. If the current call is intercom call, the phone
will reject the second intercom call
When this item is checked, the device will auto-answer phone calls by
headset if the auto-answer or intercom is enabled.
Enable Ring From Handset by selecting it, the phone plays ring tone
from handset.
Configure the Emergency Call Number. Despite the keyboard is
locked, you can dial the emergency call number
Enable Password Dial by selecting it, When number entered is
beginning with the password prefix, the following N numbers after the
password prefix will be hidden as *, N stand for the value which you
enter in the Password Length field. For example: you set the
password prefix is 3, enter the Password Length is 2, then you enter
the number 34567, it will display 3**67 on the phone.
Configure the prefix of the password call number
Enable Phone DND
Set the SIP response code on call rejection on DND
Set the SIP response code on line busy
Set the SIP response code on call rejection
Configure the Encryption Number length
Set the device to accept Active URI command from specific IP
address.
Configure the Push XML Server, when phone receives request, it will
determine whether to display corresponding content on the phone
which sent by the specified server or not.
If enabled, user can dial out with IP address
Enable phone to make calls for 10 lines max, or disable for 2 lines
max.
If enabled, user can assign default SIP line for dialing out rather than
SIP1.
Enable phone to select an available SIP line as default automatically
Play DTMF tone on the device when user pressed a phone digits
during taking, default enabled.
Play DTMF tone on the device when user pressed a phone digits at
dialing, default enabled.
Change caller ID display priority. The default priority is "Phonebook" >
50/68