New Rock Technologies NRP1002/P User Manual page 43

NRP1002/P IP Phone User Manual
Subscribe For Voice Message
Voice Message Number
Voice Message Subscribe Period
Enable DND
Blocking Anonymous Call
Use 182 Response for Call
waiting
Anonymous Call Standard
Dial Without Registered
User Agent
Use Quote in Display Name
Ring Type
Conference Type
Server Conference Number
Transfer Timeout
Enable Long Contact
Enable Missed Call Log
Response Single Codec
Use Feature Code
Enable DND
Disable DND
Enable Call Forward
Unconditional
Disable Call Forward
Unconditional
Enable Call Forward on Busy
www.newrocktech.com
answered it
Enable the device to subscribe a voice message waiting
notification, if enabled, the device will receive notification from
the server if there is voice message waiting on the server
Set the number for retrieving voice message
Set the interval of voice message notification subscription
Enable Do-Not-Disturb, any incoming call to this line will be
rejected automatically
Reject any incoming call without presenting caller ID
Set the device to use 182 response code at call waiting
response
Set the standard to be used for anonymous
Set call out by proxy without registration
Set the user agent, the default is Model with Software Version.
Whether to add quote in display name
Set the ring tone type for the line
Set the type of call conference, Local=set up call conference by
the device itself, maximum supports two remote parties,
Server=set up call conference by dialing to a conference room
on the server
Set the conference room number when conference type is set
to be Server
Set the timeout of call transfer process
Allow more parameters in contact field per RFC 3840
If enabled, the phone will save missed calls into the call history
record.
If setting enabled, the device will use single codec in response
to an incoming call request
When this setting is enabled, the features in this section will not
be handled by the device itself but by the server instead. In
order to control the enabling of the features, the device will
send feature code to the server by dialing the number specified
in each feature code field.
Set the feature code to dial to the server
Set the feature code to dial to the server
Set the feature code to dial to the server
Set the feature code to dial to the server
Set the feature code to dial to the server
42/68