Remove the HP Moonshot 1500 Chassis Management Module
6.
Management
Extend the chassis from the rack (on page 23).
7.
Remove the access panel (on page 24).
8.
Remove the midplane cover
9.
Disconnect and remove the fan cable
10.
Remove the four screws that secure the rear back-flow preventer to the chassis and slide the rear
11.
back-flow preventer towards the midplane, tilting at an angle to remove.
To replace the component, reverse the removal procedure.
Bezel ear
To remove the component:
Power down the chassis (on page 21).
1.
Open the cable management arm (on page 22).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the chassis.
b.
Disconnect all peripheral devices from the chassis.
4.
Extend the chassis from the rack (on page 23).
5.
Remove the access panel (on page 24).
6.
Module" on page 35).
("Midplane
("Fan
("HP Moonshot 1500 Chassis
cover" on page 39).
cable" on page 41).
Removal and replacement procedures 43