Power Supply; Uplink Module Blank - HP Moonshot 1500 Maintenance And Service Manual

Remove the component as indicated.
2.
To replace the component, reverse the removal procedure.

Power supply

CAUTION:
installed in each bay in the rear of chassis. When replacing a component or blank, leave the bay
empty for no more than 60 seconds. Failure to do so can disrupt airflow in the chassis.
To remove the component:
Open the cable management arm (on page 22).
1.
Remove the component as indicated.
2.
To replace the component, reverse the removal procedure.

Uplink module blank

For proper cooling, be sure that a component or a component blank is always
Removal and replacement procedures 33