Power Up The Chassis - HP Moonshot 1500 Maintenance And Service Manual

Install the chassis into the J-slot on the rails, and then pull it forward.
2.
Push in the release lever, and then install the chassis into the rack.
3.
CAUTION:
rack. Then, release the "Push" tabs and continue to slide the chassis into the rack. Press and hold
the "Push" tab on each rail again when the rails lock at a 76.2-cm (30-inch) extension. Then,
release the "Push" tabs again and finish sliding the chassis into the rack. Failure to release the
"Push" tabs may cause damage to the rails.

Power up the chassis

If the chassis was powered off while installing the cartridge, then power up the chassis. The cartridges are
hot-pluggable and do not require that you power down the chassis for installation.
Connect the power cables to the power supplies.
1.
Connect the power cables to the power source (UPS or wall outlet) or to an installed PDU.
2.
Press and hold the "Push" tab on each rail until the chassis begins to slide into the
Removal and replacement procedures 29