Hp Moonshot 1500 Chassis Management Module - HP Moonshot 1500 Maintenance And Service Manual

Remove the component as indicated.
2.
To replace the component, reverse the removal procedure.

HP Moonshot 1500 Chassis Management Module

CAUTION:
installed in each bay in the rear of chassis. When replacing a component or blank, leave the bay
empty for no more than 60 seconds. Failure to do so can disrupt airflow in the chassis.
CAUTION:
connectivity for the chassis and both switches. Before removing the module, be sure no remote
sessions are in progress.
CAUTION:
Moonshot 1500 Chassis Management Module should not be removed while a firmware update
is underway.
To remove the component:
Open the cable management arm (on page 22).
1.
Disconnect all peripheral devices from the chassis.
2.
For proper cooling, be sure that a component or a component blank is always
Removing the Moonshot 1500 CM module results in the loss of remote management
The Chassis UID flashes if a firmware update is occurring in the system. The HP
Removal and replacement procedures 35