Rear Blank - HP Moonshot 1500 Maintenance And Service Manual

CAUTION:
installed in each bay in the rear of chassis. When replacing a component or blank, leave the bay
empty for no more than 60 seconds. Failure to do so can disrupt airflow in the chassis.
To remove the component:
Open the cable management arm (on page 22).
1.
Remove the component as indicated.
2.
To replace the component, reverse the removal procedure.

Rear blank

CAUTION:
installed in each bay in the rear of chassis. When replacing a component or blank, leave the bay
empty for no more than 60 seconds. Failure to do so can disrupt airflow in the chassis.
To remove the component:
Open the cable management arm (on page 22).
1.
For proper cooling, be sure that a component or a component blank is always
For proper cooling, be sure that a component or a component blank is always
Removal and replacement procedures 34