Midplane Assembly - HP Moonshot 1500 Maintenance And Service Manual

Rotate the backplane assembly release lever down and slide the backplane assembly out of the chassis.
17.
To replace the component, reverse the removal procedure. When replacing the backplane assembly, be sure
to hold the backplane assembly level and align it carefully with the guides.

Midplane assembly

WARNING:
equipment:
Always use either a lift that can handle the load of the product or at least four people to lift and
•
stabilize the product pieces during assembly, installation, or removal, especially when the
chassis is not installed in the rack. An additional person may be required to help align the
chassis if the chassis is installed higher than chest level.
• Observe local occupational health and safety requirements and guidelines for manual
material handling.
HP recommends removing all installed components from the chassis before installing or
•
moving the chassis.
IMPORTANT:
IMPORTANT:
cartridges and switches must be returned to their original locations.
To remove the component:
Power down the chassis (on page 21).
1.
Open the cable management arm (on page 22).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the chassis.
b.
Disconnect all peripheral devices from the chassis.
4.
The chassis is very heavy. To reduce the risk of personal injury or damage to the
All components must be removed to service the midplane assembly.
Make note of the cartridge and switch locations before removing them. The
Removal and replacement procedures 53