Removal And Replacement Procedures; Required Tools; Preparation Procedures; Power Down The Chassis - HP Moonshot 1500 Maintenance And Service Manual

Removal and replacement procedures

Required tools

You need the following items for some procedures:
•
T-10 Torx screwdriver
•
T-15 Torx screwdriver

Preparation procedures

To access some components and perform certain service procedures, you might need to perform one or more
of the following procedures:
•
Power down the chassis (on page 21).
If the replacement procedure is for a non-hot-plug component or requires removing the chassis from a
rack, you must power down the chassis.
•
Open the cable management arm (on page 22).
•
Disconnect the cable management arm (on page 22).
•
Extend the chassis from the rack (on page 23).
•
Remove the access panel (on page 24).
•
Remove the chassis from the rack (on page 25).
•
Install the access panel (on page 26).
•
Install the chassis into the rack (on page 26).
•
Power up the chassis (on page 29).
•
Log in to the iLO CM firmware (on page 30).

Power down the chassis

CAUTION:
cartridge UID flashes if that target undergoing a firmware update. Chassis and target power
should not be altered while a firmware update is underway.
Log in to the iLO CM firmware (on page 30).
1.
Power down each cartridge by issuing the following commands:
2.
set node power off force <CxNy>
set node power off force all
Power down each switch by issuing the following commands:
3.
set switch power off {a|b|all}
Remove all power:
4.
Disconnect each power cord from the power source.
a.
The Chassis UID flashes if a firmware update is occurring in the system. A switch or
Removal and replacement procedures 21