HP Moonshot 1500 Maintenance And Service Manual page 27

WARNING: To reduce the risk of personal injury or damage to the equipment, be sure that:
• The rack is bolted to the floor using the concrete anchor kit.
The leveling feet extend to the floor.
•
The full weight of the rack rests on the leveling feet.
•
• The racks are coupled together in multiple rack installations.
Only one component is extended at a time. If more than one component is extended, a rack
•
might become unstable.
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before installing the chassis.
CAUTION: Always plan the rack installation so that the heaviest item is on the bottom of the rack.
Install the heaviest item first, and continue to populate the rack from the bottom to the top.
CAUTION: Be sure to keep the product parallel to the floor when installing the chassis. Tilting the
product up or down could result in damage to the slides.
CAUTION: HP has not tested or validated the HP Moonshot 1500 Chassis with any third-party
racks. Before installing the HP Moonshot 1500 Chassis in a third-party rack, be sure to properly
scope the limitations of the rack. Before proceeding with the installation, consider the following:
You must fully understand the static and dynamic load carrying capacity of the rack and be
•
sure that it can accommodate the weight of the HP Moonshot 1500 Chassis.
Be sure sufficient clearance exists for cabling, installation and removal of the chassis, and
•
actuation of the rack doors.
To install the chassis:
WARNING: To reduce the risk of personal injury or damage to the equipment, you must fully
extend the rails. To fully extend the rails, press the push tabs and extend the rails until the rails click
twice.
Fully extend the rails by pressing the push tabs and extending the rails until the rails click two times.
1.
Removal and replacement procedures 27