GE N60 Instruction Manual page 157

5 SETTINGS
IEC 61850 messaging can form part of protection schemes. Consider 61850 settings with the same criticality as
protection element settings. To ensure reliable performance of protection schemes utilizing 61850 messaging, it
can be desirable to route 61850 traffic on a separate port from SCADA communications, or to use redundant, inde-
NOTE
pendent ports, and a high speed network recovery method, such as PRP.
The N60 supports the Manufacturing Message Specification (MMS) protocol as specified by IEC 61850. MMS is supported
over two protocol stacks: TCP/IP over Ethernet. The N60 operates as an IEC 61850 server. The Remote inputs and outputs
section in this chapter describe the peer-to-peer GSSE/GOOSE message scheme.
The GSSE/GOOSE configuration main menu is divided into two areas: transmission and reception.

PATH: SETTINGS PRODUCT SETUP
 GSSE / GOOSE
 CONFIGURATION
MESSAGE
The main transmission menu is shown below:

PATH: SETTINGS PRODUCT SETUP

TRANSMISSION
 TRANSMISSION

MESSAGE
MESSAGE
MESSAGE
The general transmission settings are shown below:

PATH: SETTINGS PRODUCT SETUP
 
TRANSMISSION GENERAL
 GENERAL

The
DEFAULT GSSE/GOOSE UPDATE TIME
put state changes to be sent. When remote output data changes, GSSE or GOOSE messages are sent immediately. This
setting controls the steady-state heartbeat time interval.
The
DEFAULT GSSE/GOOSE UPDATE TIME
The GSSE settings are shown below:

PATH: SETTINGS PRODUCT SETUP
 
TRANSMISSION GSEE
 GSSE

MESSAGE
MESSAGE
These settings are applicable to GSSE only. If the fixed GOOSE function is enabled, GSSE messages are not transmitted.
GE Multilin N60 Network Stability and Synchrophasor Measurement System
 
COMMUNICATIONS IEC 61850 PROTOCOL
 TRANSMISSION

 RECEPTION

 
COMMUNICATIONS IEC 61850 PROTOCOL
 GENERAL

 GSSE

 FIXED GOOSE

 CONFIGURABLE
 GOOSE
 
COMMUNICATIONS IEC 61850 PROTOCOL
DEFAULT GSSE/GOOSE
UPDATE TIME: 60 s
sets the time between GSSE or GOOSE messages when there are no remote out-
setting is applicable to GSSE, fixed N60 GOOSE, and configurable GOOSE.
 
COMMUNICATIONS IEC 61850 PROTOCOL
GSSE FUNCTION:
Enabled
GSSE ID:
GSSEOut
DESTINATION MAC:
000000000000
5.2 PRODUCT SETUP

GSSE/GOOSE CONFIGURATION

GSSE/GOOSE CONFIGURATION

GSSE/GOOSE CONFIGURATION
Range: 1 to 60 s in steps of 1

GSSE/GOOSE CONFIGURATION
Range: Enabled, Disabled
Range: 65-character ASCII string
Range: standard MAC address
5
5-41