Advertisement
Auto Convert APs in FlexConnect Mode
This option is also available on all the current WLC platforms.
Auto Convert Mode
This mode is available only for the Flex 7500 Controller and is supported only using CLI. This mode
triggers the change on all the connected APs. It is recommended that Flex 7500 is deployed in a different
mobility domain than existing WLC campus controllers before you enable this CLI:
•
This feature is also supported on the 8510, 5520 and 8540 controllers.
(Cisco Controller) >config ap autoconvert ?
disable............Disables auto conversion of unsupported mode APs to supported modes
when AP joins
flexconnect........Converts unsupported mode APs to flexconnect mode when AP joins
monitor............Converts unsupported mode APs to monitor mode when AP joins
(Cisco Controller) >
The Auto-conversion feature is disabled by default, which can be verified by using this show command:
Step 1
(Cisco Controller) >show ap autoconvert
AP Autoconvert .................................. Disabled
Non-supported AP modes = Local Mode, Sniffer, Rogue Detector and Bridge.
Flex 7500 Wireless Branch Controller Deployment Guide
63
Advertisement
