Advertisement
Step 4
Click Apply.
Step 5
Create rules for each ACL. In order to create rules, navigate to WLC GUI > Security > Access Control
List > FlexConnect ACLs, and click the above created ACL.
Click Add New Rule.
Step 6
Configure the rules as per the requirement. If the permit any rule is not configured at the end,
Note
there is an implicit deny which will block all traffic.
Once the FlexConnect ACLs are created, it can be mapped for WLAN-VLAN mapping under individual
Step 7
FlexConnect AP or can be applied on VLAN-ACL mapping on the FlexConnect group.
Map FlexConnect ACL configured above at AP level for individual VLANs under VLAN mappings for
Step 8
individual FlexConnect AP. Navigate to WLC GUI > Wireless > All AP, click the specific AP >
FlexConnect tab > VLAN Mapping.
Flex 7500 Wireless Branch Controller Deployment Guide
FlexConnect ACL
43
Advertisement
