Advertisement
CLI Configuration
The Client ACL can be seen on the AP using the commands show access-list and show controllers
dot11Radio
Figure 58
Figure 59
http://www.cisco.com/en/US/products/ps11635/products_tech_note09186a0080b7f141.shtml
Guidelines
•
•
•
•
show access-lists Output
Client ACL on AP
Prior to AAA sending the client ACL, the ACL should be pre-created on the group or AP. The ACL
will not be dynamically downloaded to the AP at the time of client join.
A maximum of 96 ACLs can be configured on the AP.
Each ACL will have a maximum of 64 rules.
If client is already authenticated, and ACL name is changed on the radius, then client will have to
do a full authentication again to get the correct client ACL.
Flex 7500 Wireless Branch Controller Deployment Guide
Client ACL Support
101
Advertisement
