Advertisement
Under Local Authentication, click Local Users.
Step 13
Set the UserName, Password and Confirm Password fields, then click Add in order to create user entry
Step 14
in the Local EAP server residing on the AP.
Repeat step 13 until your local user name list is exhausted. You cannot configure or add more than 100
Step 15
users.
Step 16
Click Apply after step 14 is completed and the No of Users count is verified.
From the top pane, click WLANs.
Step 17
Click WLAN ID 17. This was created during the AP Group creation. See
Step 18
Under WLAN > Edit for WLAN ID 17, click Advanced.
Step 19
Check the FlexConnect Local Auth box in order to enable Local Authentication in Connected Mode.
Step 20
Local Authentication is supported only for FlexConnect with Local Switching.
Note
Always make sure to create the FlexConnect Group before enabling Local Authentication under
Note
WLAN.
Flex 7500 Wireless Branch Controller Deployment Guide
FlexConnect Groups
Figure
7.
27
Advertisement
