SANYANG INDUSTRY CO. XS125-K Service Manual page 95

11. HEADLIGHT/STEERING FRONT WHEEL/FRONT FORK
FRONT BRAKE PANEL INSPECTION
Remove the brake shoes and springs.
Remove the brake arm and brake cam.
Remove the speedmeter drive gear and dust seal.
FRONT BRAKE PANEL ASSEMBLY
Install a new dust seal.
Apply grease to the speedometer gear and install the
gear.
Apply grease to the sliding surfaces of the brake cam
and shoes as shown in the figure above.
Install the brake cam and brake arm aligning the
punch mark on the brake arm with the panch mark on
the cam.
Install the brake shoes and springs.
FRONT WHEEL RIM INSPECTION
Check the wheel rim runout by placing the wheel on
the turning stand.
Service limit:
Axial: 2.0mm under
Radial: 2.0mm under
FRONT WHEEL ASSEMBLY
Apply grease to the wheel bearings.
Install the right bearing and center collar.
Install the left bearing and dust seal.
Install the side collar.
NOTE:
Install the bearing with the sealed end facing
the outside.
11-6
BRAKE ARM
BRAKE CAM
BRAKE SHOES