SANYANG INDUSTRY CO. XS125-K Service Manual page 63

7.CLUTCH/OIL PUMP/GEAR SHIFT
Install and tighten the 20mm set ring.
Install the clutch springs, lifter plate and tighten the
bolts.
Install the bearing.
NOTE:
Tighten the bolts in a crisscross pattern in two or
three steps.
TORQUE :80-120 kgf
Install the oil filter rotor.
Install the lock washer and 16mm lock nut.
Tighten the 16mm lock nut.
TORQUE :400-500 kgf・cm
Install the filter rotor cover.
Check the oil through for a smooth operation without
binding.
Install the lifter rod.
Install the dowel pins and a new gasket.
Install the right crankcase cover
Connect the clutch cable.
Install the exhaust muffler and step bar.
Fill the crankcase with the recommended oil
Adjust the clutch lever free play.
7-6
cm
・
LOCK NUT
CLUTCH LIFTER PLATE
Dowel pin
LIFTER ROD
BEARING
FILTER ROTOR COVER