SANYANG INDUSTRY CO. XS125-K Service Manual page 51

5. CYLINDER HEAD/ VALVE
CAM SHAFT
INSTALLATION
Rotate the generator rotor and align the "T" mark with
the index mark.
Install the camshaft comp.
When intalling camshaft set, please take care that.The
line on the camsprocket should be in parallel with the
surface of cylinder head.(The IN/EX cam should be
faced down).
Install the camshaft holder.
Install the cylinder head nuts.
TORQUE:280 ~ 300 kgf
CAUTION:
The cap nut of the four holder nuts must be installed
at the left-front side.
Install the 6mm bolts.
Install the cam chain chain tensioner.
Install the auto-tensioner. (Lock the spring cap bolt
first.)
Release the auto-tensioner lock bolt.
Adjust the valve clearance.(2-7)
Install the cylinder head cover.
Install the R/L cylinder head side cover.
Install the 6mm special bolts.
NOTE:
If the cylinder head side cover gasket is damaged or
broken, replace with a new one.
cm
・
"O" MARK INDEX MARK
5-15