6.CYLINDER/PISTON
CYLINDER REMOVAL
Remove the cylinder head.
Remove the dowel pins and gasket.
Remove the cylinder.
NOTE:
Avoid the dowel pins falling into the crankcase
during removing the cylinder.
Remove the dowel pins and gasket.
Clean the cylinder gasket surface of any gasket
material.
NOTE:
Avoid damaging the cylinder gasket surface during
this operation.
CYLINDER INSPECTION
Inspect the cylinder bore for wear or damage.
Measure the cylinder I.D.
NOTE:
According to the right picture measure the cylinder
runout.
Service limit:
ITEM
Runout
Taper
I.D.
6-2
XS125-K
0.05mm
0.05mm
56.52mm