SANYANG INDUSTRY CO. XS125-K Service Manual page 92

11. HEADLIGHT/STEERING FRONT WHEEL/FRONT FORK
METER
METER REMOVAL
Remove the headlight case .
Disconnect each wire and connector.
Disconnect the meter cables.
Remove the setting screws.
Remove the meter.
HANDLEBAR
HANDLEBAR REMOVAL
Remove the wire harness.
Remove the light switch and throttle cable, remove the
turn signal switch assembly.
Remove the handlebar upper holder bolts.
Disconnect the front brake and clutch cable from the
lever.
Remove the handlebar holders and take off the
handlebar.
HANDLE BAR INSTALLATION
Connect the front brake and clutch cable to the lever.
Install the handlebar on the lower holder.
NOTE:
Align the punch marks on the handlebar with the top
of the handlebar lower holder.
Install the handlebar holders.
NOTE:
Tighten the forward bolts to the specified torque first,
then tighten the rear bolts to the same torque.
TORQUE:100~140 kg-m
Install the light switch and throttle grip.
setting screws
11-3