Important Safety & Service Notices; Safety Warnings - Redline AN-80i User Manual

1 I m p o
1 I m p o
N o t i
N o t i
1.1

Safety Warnings

1. PoE power adapter caution:
Connecting customer premises Ethernet equipment directly to the 'OUTPUT'
connector on the AN-80i Power-over-Ethernet power adapter may damage
customer network interface equipment. Customer equipment including
personal computers, routers, etc., must only be connected to the 'INPUT' port
on the PoE unit. Only the outdoors Ethernet interface cable to the AN-80i can
be safely connected to the 'OUTPUT' connector.
2. Installation of the system must be contracted to a professional installer.
3. Read this user manual and follow all operating and safety instructions.
4. Keep all product information for future reference.
5. The power requirements are indicated on the product-marking label. Do not
exceed the described limits.
6. Use only a damp cloth for cleaning. Do not use liquid or aerosol cleaners.
Disconnect the power before cleaning.
7. Disconnect power when unit is stored for long periods.
8. The AN-80i must not be located near power lines or other electrical power
circuits.
9. The system must be properly grounded to protect against power surges and
accumulated static electricity. It is the user's responsibility to install this device
in accordance with the local electrical codes: correct installation procedures for
grounding the AN-80i, mast, lead-in wire and discharge unit, location of
discharge unit, size of grounding conductors and connection requirements for
grounding electrodes.
70-00072-01-01-DRAFT
r t a n t S a
r t a n t S a
c e s
c e s
PoE Power adapter Caution
Warning to Service Personnel: 48 VDC
Proprietary Redline Communications © 2006
f e t y & S e
f e t y & S e
Page 7 of 60
AN-80i
user manual
Chapter
1
r v i c e
r v i c e
October 18, 2006