Chgver; Get; Reboot; Table 9: Cli - Chgver - Redline AN-80i User Manual

4.2.1

Chgver

Use the chgver command to change the software version to loaded when you
reboot the AN-80i. Also see the Get command 'swver'.
Command
chgver
4.2.2

Get

Use the get command to view system parameters. Use the following general
format to view a parameter:
get [field] <Enter>
Command
get
4.2.3

Reboot

Use the reboot command to remotely reset the AN-80i.
70-00072-01-01-DRAFT

Table 9: CLI - chgver

Parameter/Description
Enter this command to toggle between software versions. The setting will
alternate between the two banks of memory (no parameters).
chgver <Enter>

Table 10: CLI - get

Parameter/Description
calcdst: Calculated link distance between units.
erxpkt: Number of Ethernet packets received.
erxpktd: Number of Ethernet packets received that were discarded.
etxpkt: Number of Ethernet packets transmitted.
mac: AN-80i MAC address.
radiotype: Radio type.
rffreq: Current RF frequency setting.
rflink: Status of the RF link.
rfstatus: Status RF transmitter.
rssimax: Maximum RSSI.
rssimean: Mean RSSI.
rssimin: Minimum RSSI.
sinadr: Ration of signal to interference + noise.
swver: List the downloaded software versions.
sysuptime: Display the time since the last reboot.
txpower: Current Tx power setting.
ubrate: Current UBR value.
wrxpkt: Number of wireless packets received.
wrxpktd: Number of wireless packets received that were discarded.
wrxpktr: Number of wireless packets that were retransmitted.
wtxpkt: Number of wireless packets transmitted.
wtxpktd: Number of wireless packets transmitted that were discarded.
wtxpktr: Number of wireless packets that were retransmitted.
Proprietary Redline Communications © 2006
Page 38 of 60
AN-80i
user manual
October 18, 2006