Antenna Alignment; Indoor Power Block (Poe Power Adapter); Figure 3: Intro - Indoor Power-Over-Ethernet (Poe) Module - Redline AN-80i User Manual

2.5

Antenna Alignment

The AN-80i includes an audible antenna alignment tool to assist in pointing the
antenna for maximum signal strength. The signal will sound infrequently when a
low signal is detected, and more often as the signal strength increases. The audible
signal is enabled and disabled through the user interface:
Telnet: see buzzer in section 4.2.6 Set on page 39
Web: see Antenna Alignment Buzzer Enable in section 3.5 System Configuration
Screen on page 21
2.6

Indoor Power Block (PoE Power Adapter)

The PoE power adapter provides operational power and connection to a local
Ethernet network. The power block provides two Ethernet interfaces:
INPUT: The 10/100Base-T Ethernet port (RJ-45) for connection to local
network equipment.
OUTPUT: The 10/100Base-T Ethernet port (RJ-45) port to carry signal and
power to the AN-80i.

Figure 3: Intro - Indoor Power-over-Ethernet (PoE) Module

Use the AN-80i only with Cincon PoE Adapter Model TR60A-POE-L.
Connecting customer premises Ethernet equipment directly to the 'OUTPUT'
connector on the AN-80i Power-over-Ethernet power adapter may damage
customer network interface equipment. Customer equipment including
personal computers, routers, etc., must only be connected to the 'INPUT' port
on the PoE unit. Only the outdoors Ethernet interface cable to the AN-80i can
be safely connected to the 'OUTPUT' connector.
70-00072-01-01-DRAFT
Important: PoE Adapter Type
PoE Power Adapter Caution
Warning to Service Personnel: 48 VDC
Proprietary Redline Communications © 2006
Page 13 of 60
AN-80i
user manual
October 18, 2006