Testing And Saving System Parameters; Web Interface; Cli Interface; Figure 18: Diag - Saving Parameters In Nvram - Redline AN-80i User Manual

AN-80i
user manual
5.3

Testing and Saving System Parameters

The AN-80i is a highly configurable communications device. All configurable
options are saved in non-volatile RAM. The system configuration and snmp
settings are saved separately.

Web Interface

The Test button is located on the System Configuration page. Click this button to
have the AN-80i load the current settings displayed in the configuration screen.
The AN-80i will operate with these settings for a period of five minutes. During
the test period you may click the Save button at any time to save this configuration
permanently (also terminating the five minute timer). After five minutes, if the
Save function button has not been applied, the AN-80i will reboot and load the
previously saved settings.

Figure 18: Diag - Saving Parameters in NVRAM

CLI Interface

Use the 'test' command to have the AN-80i load the edited settings. The AN-80i
will operate with these settings for a period of five minutes. During the test period,
you may click the Save button at any time to save this configuration permanently.
Otherwise, after five minutes, the AN-80i will reboot and load the previously
saved settings.
Note: Factory defaults can only be restored using the CLI commands.
70-00072-01-01-DRAFT Proprietary Redline Communications © 2006 October 18, 2006
Page 49 of 60