Show; Table 15: Cli - Show - Redline AN-80i User Manual

4.2.7

Show

Use the show command to display system statistics.
show <Enter>
show [field] <Enter>
Command
70-00072-01-01-DRAFT
Table 14: CLI - set
snmp: SNMP enable setting.
off - Disable the SNMP agent.
on - Enable the SNMP agent.
sntp: SNTP enable setting.
off - Disable SNTP protocol support.
on - Enable SNTP protocol support.
sntpip: Enter the SNTP server IP address. Valid only if sntp is enabled.
syscontact: Enter additional descriptive details about this AN-80i. The
description can be any combination of up to 20 letters and numbers.
sysdescr: Enter descriptive details about this AN-80i. The description
can be any combination of up to 20 letters and numbers.
sysloc: Enter descriptive details about the location of this AN-80i. The
description can be any combination of up to 20 letters and numbers.
syslog: Syslog enable setting.
off - Disable syslog server protocol support.
on - Enable syslog server protocol support.
syslogip: Enter the syslog server IP address. Valid only if syslog is
enabled.
sysmode: The system designated as master establishes and manages
the bi-directional data link with a remote end AN-80i. Only one system in
a wireless link must be set for Master mode.
ptpmaster - This unit begins transmitting automatically; sending
poll messages to locate the remote AN-80i and then
negotiates to establish the wireless link.
ptpslave - This unit waits passively, monitoring the selected
channel(s) until polled by the PTP Master, and then
negotiates to establish the wireless link.
sysname: Enter the name for this AN-80i. The name can be any
combination of up to 20 letters and numbers.
telnet: Enable or disable the Telnet port. If the Telnet port is disabled, it
will not be possible to use the CLI interface.
off - Disable
on - Enable
Changes to this field are effective only following reboot.
telnetport: Enter Telnet port address (default is 23).
Change to 'show' mode.
Display values for the selected parameter.

Table 15: CLI - show

Description
Proprietary Redline Communications © 2006
Page 42 of 60
AN-80i
user manual
October 18, 2006