Wireless Configuration; Table 1: Web - Rf Channel Range; Table 2: Web - Max. Power (In Dbm) And Modulation Settings - Redline AN-80i User Manual

HTTP Enable: Check this box
option is deselected, only CLI commands will be available.
Telnet Enable: Check this box
Refer to the CLI commands in section 4: CLI Interface on page 36.
Telnet Port: Enter Telnet port address (default is 23).
SNMP Enable: Check this box
Protocol (SNMP) agent. When this item is checked, clicking on the blue text
[Configure SNMP] adjacent to the check box displays the SNMP Configuration
screen. See section 3.9: SNMP Settings on page 31 for additional information on
SNMP settings for the AN-80i.

Wireless Configuration

RF Freq. [MHz]: Enter the center frequency for the RF channel. The options key
controls channel availability. The table below specifies the center frequencies of
each available channel.
Channel Size
10 MHz
20 MHz
40 MHz
To minimize interference, the channel frequencies for AN-80i links operating in
close proximity should be separated by a minimum of the channel size in use (to
avoid overlapping bands).
Auto scan: Check this box
scan available channels and locate the current operating frequency of the AN-80i
PTP Master.
Tx Power [dBm]: Enter the transmit power level (dBm). This setting is for the
transceiver output only. The actual EIRP depends on the gain of the connected
antenna (see section 6.2: Antenna and Power Specifications on page 56).
Important: In some regions, the maximum operational power per channel for a
specific antenna is limited in accordance with regulations specifying the maximum
allowable EIRP levels. Refer to the FCC and CE notices in this manual.
See Table 2: Web - Max. Power (in dBm) and Modulation to determine the
maximum transmit power level available at each modulation setting. When ATPC
is enabled, the Tx power will be automatically adjusted to achieve optimum
performance.

Table 2: Web - Max. Power (in dBm) and Modulation Settings

Modulation BPSK
Code Rate 1/2
Max Tx 20
Power
70-00072-01-01-DRAFT
to enable the HTTP (Web) interface. If the
to enable a Telnet access (CLI) to the AN-80i.
to enable the Simple Network Management

Table 1: Web - RF Channel Range

to enable the AN-80i PTP Slave to automatically
QPSK
3/4 1/2 3/4
20 20 20
Proprietary Redline Communications © 2006
Page 23 of 60
Frequency Selection (2.5 MHz steps)
5730 - 5845 MHz
5735 - 5840 MHz
5745 - 5830 MHz
16 QAM
1/2 3/4
20 20
AN-80i
user manual
64 QAM
2/3 3/4
16 16
October 18, 2006