Procedure To Reset An-80I Ip Address; Procedure; Figure 17: Cli - Recovering Lost Ip Address - Redline AN-80i User Manual

5.2

Procedure to Reset AN-80i IP Address

The AN-80i features a method to gain access to the CLI commands for a unit
where the IP address, username, and/or password is unknown. This method
requires local access to the AN-80i PoE power adapter, the capability to power-
cycle the AN-80i, a PC with a telnet client, and an Ethernet cable.
5.2.1

Procedure

1. Power-off the AN-80i PoE power adapter. Remove the network Ethernet cable
and connect your computer directly to the PoE power adapter 'INPUT' Ethernet
port (requires Cat 5e cross-over cable).
2. Open a command prompt window on the PC and enter the command:
telnet 192.168.25.2
3. Power-on the AN-80i PoE power adapter for over 30 seconds.
4. Power-off the AN-80i PoE power adapter for 7 seconds.
5. Power-on the AN-80i PoE power adapter, wait 15 seconds, and then press the
Enter key on the PC (to start the Telnet session). The Telnet session must
connect to the AN-80i within 10 to 30 seconds from when the AN-80i starts
the second time.
6. When prompted, login using 'admin' as the user name and 'admin' as password.
7. Use the following commands to save a new IP address:
ipaddr <IP Address> <Enter>
save config <Enter>
If required, use the 'user' command to enter new username and password
information (4.2.12 User on page 46 ) or the 'save' command to reset all
parameters to factory default settings (4.2.5: Save on page 39).
8. Power-off the AN-80i, restore the network connections, and restore power.
70-00072-01-01-DRAFT

Figure 17: CLI - Recovering Lost IP Address

<Do not press Enter key at this time>
Proprietary Redline Communications © 2006
Page 48 of 60
AN-80i
user manual
October 18, 2006