Table 3: Web - Ethernet Status Indication - Redline AN-80i User Manual

Channel Width: Select the channel bandwidth. See Table 1: Web - RF Channel
Range.
Modulation Reduction Level: Enter the number of modulation/coding levels to
step down during re-transmission of errored wireless packets. Each step down
lowers the UBR. The level can be set from 0 to 7 (recommended value = 2).
Uncoded Burst Rate [Mb/s]: Select the desired UBR for the link. If Adaptive
Modulation is disabled, the AN-80i will transmit using only the specified settings.
See Table 2: Web - Max. Power (in dBm) and Modulation.
Ethernet Follows Wireless: Check this box
enable the Ethernet port function based on the status of the wireless interface. This
feature allows switches and routers to trigger configuration changes based on
changes to the AN-80i Ethernet port status.
Disabled ( ): The AN-80i Ethernet port is always enabled.
Enabled ( ): The Ethernet port status is controlled based on the status of the
wireless interface. See the following table.

Table 3: Web - Ethernet Status Indication

Configuration Setting
Ethernet Follows Wireless
Ethernet Follows Wireless
Important: Enabling the
management traffic (HTTP, TELNET, and SNMP). While the wireless interface is
down, it is not possible to establish communications with the AN-80i using the
Ethernet port. If the wireless interface is down, the
can only be set to 'off' by using the IP recovery procedure. See 5.2: Procedure to
Reset AN-80i IP Address on page 48.
System Mode: The PTP Master establishes and manages the bi-directional data
link with a remote end AN-80i. Only one system in a wireless link must be set for
PTP Master mode.
PTP Master: This unit begins transmitting automatically; sends poll messages
to the remote AN-80i, and negotiates the wireless link.
PTP Slave: This unit waits passively, monitoring the selected channel(s) until
polled by the PTP Master, and participates in negotiating the wireless link.
Software Version: Select the version of system software to load when the AN-80i
is rebooted. The system holds two independent software images.
Encryption Enable: Check this box
over the wireless interface. When encryption is enabled, no Ethernet packets can
be transferred over-the-air unless encryption is enabled on the remote-end AN-80i,
and the correct encryption key is entered on both AN-80i units.
70-00072-01-01-DRAFT
Wireless interface
Status
Link Up
Link Down
Link Up
Link Down
Ethernet Follows Wireless
to enable encryption of data transmitted
Proprietary Redline Communications © 2006
Page 25 of 60
AN-80i
user manual
to have the AN-80i disable and
Ethernet Port Status
Enabled
Enabled
Enabled
Disabled
setting affects all data and
Ethernet Follows Wireless
October 18, 2006
setting