Controls - Redline AN-80i User Manual

Encryption Key: The key is used to encrypt data in a way that can be decoded by
the remote-end AN-80i. Enter the MAC address of the communicating AN-80i.
Link Length Measurement Mode: Select the mode for setting/measuring the
distance between this and the remote-end AN-80i.
Auto: Distance is calculated automatically by the AN-80i.
Manual: Enter the link distance manually in the Link Length field.
Link Length: Enter the actual length of the path that the radio wave travels
between the two AN-80i units. The Link length is used to calculate the
transmission-to-response interval and reject reflections of the transmitted signal.
This setting is valid only when the Link Length Mode is set to Manual.
Link Length Measurements Unit: Select the units for the Link Length field.
Mile: Link length distance is displayed in miles.
Km: Link length distance is displayed in kilometers.
Antenna Alignment Buzzer Enable: Check this box
alignment audible tone generator in the transceiver. The rate of the tone is
proportional to the receive signal strength (faster = stronger signal).
Radio Enable: Check this box
unchecked ( ), it will not be possible to establish a wireless link.

Controls

Save: Click this button to save the parameter settings displayed in the
configuration screen.
Note: Changes to some parameters cause the AN-80i to initiate a system reset
when the Save button is selected.
Test: Click this button to have the AN-80i load the current settings displayed in
the configuration screen. The AN-80i will operate with these settings for a period
of five minutes. During the 'test' period, you may click the Save button at any time
to save this configuration permanently (also terminating the five minute timer). If
the Save button is not selected during the five minute test period, the AN-80i is
rebooted and the previously saved settings are reloaded.
System Reboot: Click this button to immediately reboot the AN-80i. All statistics
counters are reset.
70-00072-01-01-DRAFT
to enable the radio transmitter. If this box is
Proprietary Redline Communications © 2006
Page 26 of 60
AN-80i
user manual
to enable the antenna
October 18, 2006