Change Snmp Trap Configuration; Figure 14: Web - Snmp Add/Change Community Screen - Redline AN-80i User Manual

Read: Grant read access permission only for this entry. Deny write permission.
Write: Grant write access permission only for this entry. Deny read permission.
Read&Write: Grant read and write access permission for this entry.
Change Community: Click the Change Community button to copy these settings
to the community settings table. This action does not permanently save changes.
To save changes to the community settings you must also click the Save Comm
button in the SNMP Configuration screen.
3.9.2

Change SNMP Trap Configuration

Each of the eight entries in the SNMP Traps Management table may be changed
individually. Click the Chg button to modify the settings for the adjacent entry.
Index: Display the table position number for this entry. Position 0 is the first entry.
IP Address: Enter the IP address (IPv4) associated with this SNMP alarm.
Port: Enter the destination port address associated with this SNMP alarm.
Community Name: Enter the SNMP community name for this entry.
Change Trap: Click the Change Trap button to copy these settings to the
community settings table. This action does not permanently save changes. To save
changes to the SNMP trap settings you must click the Save Traps button in the
SNMP Configuration screen.
70-00072-01-01-DRAFT

Figure 14: Web - SNMP Add/Change Community Screen

Proprietary Redline Communications © 2006
Page 33 of 60
AN-80i
user manual
October 18, 2006