Change Snmp Community; Figure 13: Web - Snmp Add/Change Community Screen - Redline AN-80i User Manual

SNMP Community Management
Community Name: Displays the SNMP community name for each entry
(maximum of eight entries).
Access: Displays the access permissions for each SNMP community.
None: Deny read and write permission for this community.
Read: Grant read access permission only for this community. Deny write
permission.
Write: Grant write access permission only for this community. Deny read
permission.
Read&Write: Grant read and write access permission for this community.
Chg: Click the Chg button to modify the settings for the adjacent entry.
Save Comm: Click the Save Comm button to save changes to the community
settings.
SNMP Traps Management
IP Address(IPv4): IP address associated with this SNMP alarm.
Port: Destination port address associated with this SNMP alarm.
Community: Community associated with this SNMP alarm.
Chg: Click the Chg button to modify the settings for the adjacent entry.
SNMP Traps Enabled: Check this box
box is not checked, all SNMP traps are disabled.
Link Up/Down Trap Enabled: Check this box
generated for each link up and link down event.
Save Traps: Click the Save Traps button to save changes to the SNMP trap
settings.
3.9.1

Change SNMP Community

Each entry in the SNMP Community Management table may be changed
individually. Click the Chg button adjacent to any entry to modify the settings.
Index: Display the unique reference number for this entry.
Community Name: Enter or modify the SNMP community name for this entry.
Access Rights: Select the access permissions for this entry.
None: Deny read and write permission for this entry.
70-00072-01-01-DRAFT

Figure 13: Web - SNMP Add/Change Community Screen

Proprietary Redline Communications © 2006
to enable SNMP traps to be sent. If the
to enable an SNMP trap to be
Page 32 of 60
AN-80i
user manual
October 18, 2006