Electrolux EVYP9841A Owner's Manual page 18

18 www.electrolux.com
10.2 Using the Child Lock
The Child Lock prevents an accidental
operation of the appliance.
1. Activate the appliance.
2. Touch
until the display shows a message.
To deactivate the Child Lock function
repeat step 2.
10.3 Function Lock
This function prevents an accidental
change of the heating function. You can
activate it only when the appliance
operates.
1. Activate the appliance.
2. Set a heating function or setting.
3. Press
display shows: Function Lock.
4. Press
To deactivate the function, press
display shows a message. Press
and then
10.4 Set + Go
The function lets you set a heating
function (or a programme) and use it later
with one press of a sensor field.
1. Activate the appliance.
2. Set a heating function.
3. Press
display shows: Duration.
4. Set the time.
5. Press
display shows: Set + Go.
6. Press
Press a sensor field (except for
the function: Set + Go. The set heating
function starts.
When the heating function ends, an
acoustic signal sounds.
and at the same time
again and again until the
to confirm.
to confirm.
When you deactivate the
appliance, the function also
deactivates.
again and again until the
again and again until the
to confirm.
10.5 Automatic Switch-off
For safety reasons the appliance
deactivates automatically after some time
if a heating function operates and you do
not change any settings.
Temperature (°C) Switch-off time
30 - 115
120 - 195
200 - 230
. The
again
10.6 Brightness of the display
There are two modes of display
brightness:
• Night brightness - when the appliance
is deactivated, the brightness of the
display is lower between 10 PM and 6
AM.
• Day brightness:
– when the appliance is activated.
– if you touch a sensor field during
the night brightness (apart from
ON / OFF), the display goes back
to the day brightness mode for the
next 10 seconds.
) to start
– if the appliance is deactivated and
you set the function: Minute
Minder. When the function ends,
the display goes back to the night
brightness.
• Function Lock is on when
the heating function
operates.
• The menu: Basic Settings
lets you activate and
deactivate the function:
Set + Go.
(h)
12.5
8.5
5.5
The Automatic switch-off
does not work with the
functions: Light, core
temperature sensor, End
Time, Duration.