Table of Contents
Advertisement
Available languages
Available languages
The installation software is started.
2.
Follow the instructions on the screen.
3.
Plug the flat USB connector on one end of the supplied USB cable into a USB port on
the PC.
4.
Plug the other USB connector into the USB port labelled
telephone.
Installing the TAPI Driver (only COMfortel 2600)
The TAPI driver enables you to use TAPI applications from the USB port on the Auerswald
USB device.
Note: Only Windows 7 and Windows 8/8.1 applications are supported.
Requirements
•
Installation file (Setup.exe) stored on a storage medium (PC)
•
Completed installation of the USB Driver
1.
Start the installation file (Setup.exe) on the PC.
The installation software is started.
2.
Follow the instructions on the screen.
Installing the COMfortel Set Configuration Software
Requirements
•
A PC meeting the system requirements (see chapter Important Information > System
Requirements,
•
Installation file (comftelset.exe) stored on a storage medium (PC)
•
Active connection of the PC to one of the following interfaces:
– USB interface of the telephone (only COMfortel 2600; see
– PC port on the PBX (see the instructions of the PBX)
COMfortel 1600/2600 - Firmware V1.8 - COMfortel Set V3.10.0 - Setup V07 09/2016
page
39)
Commissioning
on the back of the system
page
50)
51
Advertisement
Table of Contents
