Table of Contents
Advertisement
Available languages
Available languages
• Comfortel 2600: Tap on OK.
Further Steps
•
Once you have carried out the firmware update, you can distribute this new firmware ver-
sion from this telephone to all the other system telephones of the same design con-
nected to the PBX.
Note: If there are system telephones of different designs, an additional manual firmware
update is necessary for each design.
•
In order to use new features after a firmware update, you usually need a new version of
the COMfortel Set configuration software as well as a new version of the Operation
Guide. Both can be found in the internet (see www.auerswald.de/service).
•
In order to use the new features after a firmware update of the telephone, an update of
the PBX firmware is often necessary (see instructions of the PBX).
Distributing Firmware
Note: If there are system telephones of different designs, the firmware has to be distrib-
uted for each design.
Requirements
•
New firmware version on the distributing telephone
1.
Press the menu key.
2.
Tap successively on settings > synchronisation > distr. firmware.
The firmware is distributed. During the distribution process, Server Mode is dis-
played on the distributing telephone. It is not possible to use the telephone during
this process.
COMfortel 1600/2600 - Firmware V1.8 - COMfortel Set V3.10.0 - Setup V07 09/2016
Appendix
55
Advertisement
Table of Contents
