Lead Assembly Installed In Grommet; Wire Doubled Over For Installation Of Eyelet - Piper ARROW III Service Manual

Figure 8-26. Lead Assembly Installed in Grommet
17. Install the clamps and cable ties, as necessary, to secure the lead to the engine.
Leads should be dressed away from hot spots, such as manifolds and sharp
edges which cause chafing.
8-44. INSTA L L ATION OF HARNESS. Before installing the harness plate on the magneto, check the mating
surfaces for cleanliness. Spray the entire face of the grommet with a light coat of Plastic Mold Spray, SM-O-O-TH
Silicone Spray or equivalent. This will prevent the harness grommet from sticking to the magneto distributor block.
a. Place the harness terminal plate on the magneto and tighten the nuts around the plate alternately to seat
the cover squarely on the magneto. Torque the nuts to 18 to 22 inch-pounds.
b. Route the ignition wires to their respective cylinders as shown in Figure 8-28.
c. Clamp the harness assembly in position.
d. Connect the leads to the spark plugs.
Revised: 8/31/77
CHEROKEE ARROW III SERVICE MANUAL
CAUTION
2B20
Figure 8-27. Wire Doubled Over
For Installation of Eyelet
POWER PLANT - CONTINENTAL