Troubleshooting Chart (Surface Controls) - Piper ARROW III Service Manual

TABLE V-III. TROUBLESHOOTING CHART (SURFACE CONTROLS)
Trouble
Lost motion between con-
trol wheel and aileron.
Resistance to control
wheel rotation.
Issued: 12/15/76
CHEROKEE ARROW III SERVICE MANUAL
AILERON CONTROL SYSTEM
Cable Tension too low.
Linkage loose or worn.
Broken pulley.
Cables not in place on
pulleys.
System not lubricated
properly.
Cable tension too high.
Control column hori-
zontal chain improperly
adjusted.
Pulleys binding or
rubbing.
Cables not in place on
pulleys.
Bent aileron and/or
hinge.
Cables crossed or
routed incorrectly.
Cause
1G20
Remedy
Adjust cable tension.
(Refer to Paragraph
5-12.)
Check linkage and
tighten or replace.
Replace pulley.
Install cables cor-
rectly. Check cable
guards.
Lubricate system.
Adjust cable tension.
(Refer to Paragraph
5-12.)
Adjust chain tension.
(Refer to Paragraph
5-6.)
Replace binding pulleys
and/or provide clearance
between pulleys and
brackets.
Install cables cor-
rectly. Check cable
guards.
Repair or replace ai-
leron and/or hinge.
Check routing of control
cables.
SURFACE CONTROLS