Avaya J129 User Manual page 4

2. This device must accept any interference, including
1
interference that may cause undesired operation of the
2
device.
3
Le présent appareil est conforme aux CNR d'Industrie Canada
4
applicables aux appareils radio exempts de licence. L'exploitation est
5
autorisée aux deux conditions suivantes:
6
1. L'appareil ne doit pas produire de brouillage, et
7
2. L'utilisateur de l'appareil doit accepter tout brouillage
8
radioélectrique subi, même si le brouillage est susceptible
9
d'en compromettre le fonctionnement.
10
Radio Transmitter Statement
11
Under Industry Canada regulations, this radio transmitter may only
12
operate using an antenna of a type and maximum (or lesser) gain
13
approved for the transmitter by Industry Canada. To reduce potential
14
radio interference to other users, the antenna type and its gain
15
should be so chosen that the equivalent isotropically radiated power
16
(EIRP) is not more than that necessary for successful
17
communication.
18
Conformément à la réglementation d'Industrie Canada, le présent
19
émetteur radio peut fonctionner avec une antenne d'un type et d'un
20
gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie
21
Canada. Dans le but de réduire les risques de brouillage
22
radioélectrique à l'intention des autres utilisateurs, il faut choisir le
23
type d'antenne et son gain de sorte que la puissance isotrope
24
rayonnée équivalente ne dépasse pas l'intensité nécessaire à
25
l'établissement d'une communication satisfaisante.
26
This Class B digital apparatus complies with Canadian ICES-003.
27
Cet appareil numérique de la classe B est conforme à la norme
28
NMB-003 du Canada.
29
Radiation Exposure Statement
30
This equipment complies with FCC & IC RSS102 radiation exposure
31
limits set forth for an uncontrolled environment. This equipment
32
should be installed and operated with minimum distance 20cm
33
between the radiator & your body. This transmitter must not be co-
34
located or operating in conjunction with any other antenna or
35
transmitter.
36
Cet équipement est conforme aux limites d'exposition aux
37
rayonnements ISEDétablies pour un environnement non contrôlé.
38
Cet équipement doit être installé et utilisé avec un minimum de 20
39
cm de distance entre la source de rayonnement et votre corps.
40
Japan Statements
41
Class B Statement
42
This is a Class B product based on the standard of the VCCI Council.
43
If this is used near a radio or television receiver in a domestic
44
environment, it may cause radio interference. Install and use the
45
equipment according to the instruction manual.
46
47
Denan Power Cord Statement
48
Danger:
Please be careful of the following while installing the
49
equipment:
50
• Please only use the connecting cables, power cord, and
51
AC adapters shipped with the equipment or specified by
52
Avaya to be used with the equipment. If you use any
53
other equipment, it may cause failures, malfunctioning,
54
or fire.
55
• Power cords shipped with this equipment must not be
56
used with any other equipment. In case the above
57
guidelines are not followed, it may lead to death or
58
severe injury.
59
60
本製品を安全にご使用頂くため、以下のことにご注意ください。
61
• 接続ケーブル、電源コード、AC アダプタなどの部品は、必ず
62
製品に同梱されております添付品または指定品をご使用くだ
63
さい。添付品指定品以外の部品をご使用になると故障や動作
64
不良、火災の原因となることがあります。
65
• 同梱されております付属の電源コードを他の機器には使用し
66
ないでください。上記注意事項を守らないと、死亡や大怪我
67
など人身事故の原因となることがあります。
68
México Statement
69
The operation of this equipment is subject to the following two
70
conditions:
71
1. It is possible that this equipment or device may not cause
72
harmful interference, and
73
2. This equipment or device must accept any interference,
74
including interference that may cause undesired operation.
75
La operación de este equipo está sujeta a las siguientes dos
76
condiciones:
77
1. Es posible que este equipo o dispositivo no cause
78
interferencia perjudicial y
79
2. Este equipo o dispositivo debe aceptar cualquier
80
interferencia, incluyendo la que pueda causar su operación
81
no deseada.
82
Power over Ethernet (PoE) Statement
83
This equipment must be connected to PoE networks without routing
84
to the outside plant.
85
U.S. Federal Communications Commission (FCC) Statements
86
Compliance Statement
87
The changes or modifications not expressly approved by the party
88
responsible for compliance could void the user's authority to operate
89
the equipment.
90
To comply with the FCC RF exposure compliance requirements, this
91
device and its antenna must not be co-located or operating to
92
conjunction with any other antenna or transmitter.
93
This device complies with part 15 of the FCC Rules. Operation is
94
subject to the following two conditions:
95
1. This device may not cause harmful interference, and
96
2. This device must accept any interference received,
97
including interferences that may cause undesired
98
operation.
99
When using IEEE 802.11a wireless LAN, this product is restricted to
100
indoor use, due to its operation in the 5.15 to 5.25GHz frequency
101
range. The FCC requires this product to be used indoors for the
102
frequency range of 5.15 to 5.25GHz to reduce the potential for
103
harmful interference to co channel mobile satellite systems. High-
104
power radar is allocated as the primary user of the 5.25 to 5.35GHz
105
and 5.65 to 5.85GHz bands. These radar stations can cause
106
interference with and/or damage to this device.
107
Class B Part 15 Statement
108
For product available in the USA/Canada market, only channel 1~11
109
can be operated. Selection of other channels is not possible.
110
This equipment has been tested and found to comply with the limits
111
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
112
These limits are designated to provide reasonable protection against
113
harmful interferences in a residential installation. This equipment
114
generates, uses and can radiate radio frequency energy and, if not
115
installed and used in accordance with the instructions, may cause
116
harmful interference to radio communications. However, there is no
117
guarantee that interference will not occur in a particular installation. If
118
this equipment does cause harmful interferences to radio or
119
television reception, which can be determined by turning the
60