T01-05 Hard Disk Controller - Huawei Tecal RH2485 V2 Operation Manual

Acceptance Manual
Tecal RH2485 V2 Server
Test Description

T01-05 Hard Disk Controller

T01-0501 Verifying the LSI2308 Hard Disk Controller
Objective
Test Networking
Diagram
Preset Conditions
Test Procedures
Expected Result
Test Description
T01-0502 Verifying the LSI2208 Hard Disk Controller
Objective
Test Networking
Diagram
Preset Conditions
Test Procedures
6. The BIOS version is displayed.
7. No abnormal noise is heard during the startup.
None
To verify that the hard disk controller operates properly.
None
The structure of the mainboard, hard disk backplane, I/O board, indicator board, VGA
board, and power board is proper, and hard disks are detected after the server is
powered on.
1. Press Ctrl+C as prompted during the startup.
2. View the LSI2308 BIOS version and firmware versions on the displayed
screen.
3. On the Adapter Properties screen, check the NVDATA version.
4. On the SAS Topology menu, expand Direct Attach Devices, and check the
hard disk model and quantity.
1. The SETUP screen is displayed after you press Ctrl+C.
2. The LSI2308 BIOS version, firmware versions, and NVDATA version are
displayed.
3. The hard disk model and quantity are the same as actual configurations.
None
To verify that the hard disk controller operates properly.
None
The structure of the mainboard, hard disk backplane, I/O board, indicator board, VGA
board, and power board is proper, and hard disks are detected after the server is
powered on.
1. Press Ctrl+H as prompted during the startup.
2. In the Adapter Selection window, click Start. Check that the window for
configuring the hard disk controller is displayed.
3. In the Physical View window, view the hard disk quantity, installation positions,
and capacity.
4. In the Controller Properties window, view the firmware versions, firmware
package version, and WebBIOS version.
4
Part II Operation Guide