T03 Os; T03-01 Os Installation And Functions - Huawei Tecal RH2485 V2 Operation Manual

Acceptance Manual
Tecal RH2485 V2 Server
Test Description

T03 OS

T03-01 OS Installation and Functions

T03-0101 Verifying Linux Installation and Functions
Objective
Test Networking
Diagram
Preset Conditions
Test Procedures
Expected Result
Test Description
T03-0102 Verifying Windows Installation and Functions
Objective
Test Networking
Diagram
4. The status of all fans is shown as
5. The hard disk and DIMM installation status are the same as actual site
information.
6. The network delay is shorter than 3s.
None
To verify that a Linux OS is properly installed, detected, and operating
None
The structure of the mainboard and hard disk backplane is proper, and hard disks are
detected after the server is powered on.
1. Install a Linux OS and hardware drivers.
2. Log in to the OS and run the cat /etc/*release command to view the OS
version, patch version, bits.
3. Run the free command, and view the total memory capacity.
4. Run the top command and press 1. View the number of the CPU kernels.
Run the dmidecode |grep –i cpu command, and view the CPU model.
5.
6. Run the lspci command, and view the number of network interface cards
(NICs) and host bus adapter (HBA) card information.
1. The OS is properly installed, and the hard disks and the CD-ROM drive are
successfully detected.
2. The OS version, patch version, and bits are the same as actual configurations.
3. The total memory capacity is compatible with actual configurations.
4. The CPU model and kernel quantity are the same as actual configurations.
5. The number of NICs is the same as actual configurations.
6. The HBA card information is the same as actual configurations.
None
To verify that a Windows OS is properly installed, detected, and operating
None
.
7
Part II Operation Guide