T04-08 Setting The System Boot Option; T05 Hard Disk Controller Functions; T05-01 Configuring Raid 1 Properties By Using The Hard Disk Controller Lsi2308 - Huawei Tecal RH2485 V2 Operation Manual

Acceptance Manual
Tecal RH2485 V2 Server
Expected Result
Test Description

T04-08 Setting the System Boot Option

Objective
Test Networking
Diagram
Preset Conditions
Test Procedures
Expected Result
Test Description

T05 Hard Disk Controller Functions

T05-01 Configuring RAID 1 Properties by Using the Hard Disk Controller
LSI SAS2308
T05-0101 Configuring RAID 1 Properties by Using the Hard Disk Controller LSI SAS2308
3. Select Steady On and click OK.
4. Choose Temporary On, enter a time period for illumination, such as 10
seconds, and click OK.
5. Select Off and click OK. Observe the status of the location indicator on the
server.
The indicator shows the three states properly and the selected state is the same as
the actual state.
When the location indicator is illuminated, it blinks blue at 1 Hz.
To verify that you can set the system boot option on the iMana Web.
None
1. AC power is supplied to the server.
2. The IP address of the iMana management network port is obtained.
3. Internet Explorer 8.0 or Firefox 9.0 is installed on the terminal.
4. JRE1.6u25 or later is installed on the terminal.
5. The terminal is connected to the iMana network port of the server over the
network.
6. The CD-ROM drive is connected to the server.
1. Log in to the iMana Web.
2. Choose Configuration, click System Configuration, and click System Boot
Option on the right.
3. Select CD-ROM Drive and click OK.
4. Restart the server and check whether the setting takes effect.
5. Select No override and click OK.
6. Restart the server and check whether the setting takes effect.
1. The system boots from the CD-ROM drive.
2. The system boots based on the BIOS settings.
12
Part II Operation Guide